EPF Foam Fire and Performance Safety

EPF Foam Fire and Performance Safety

Fire Performance & Safety

Like practically all organic building materials polystyrene foam is combustible. However, in practice, its burning behavior depends on the conditions under which it is used, as well as the inherent properties of the material. When installed correctly, expanded polystyrene products do not present an undue fire hazard. It is recommended that expanded polystyrene should be protected by a thermal barrier in specific applications as referenced in the International Code Council (ICC) and Canadian Materials Construction Centre (CMCC) building codes.

 When burning, expanded polystyrene behaves like other hydrocarbons such as wood, paper, etc. If EPS is exposed to temperatures above 212° F (100° C), it begins to soften, to contract and finally to melt. Whether or not these can be ignited by a flame or spark depends largely on the temperature, duration of exposure to heat and air flow around the material (the oxygen availability).

Under certain fire conditions, EPS will ignite when exposed to an open flame. The transfer ignition temperature is typically 680°F (360°C). Although foam insulation is relatively difficult to ignite, in the case of ignition, burning will readily spread over the exposed surface of the EPS and it will continue to burn until all EPS is consumed. While the low density of the foam contributes to the ease of burning through a higher ratio of air (98%) to polystyrene (2%), the mass of the material present is low and hence the amount of heat released is also low. Ignited EPS will produce a dense smoke that will result in carbon monoxide, monostyrene, hydrogen bromide and other aromatic compounds. It is important to note that these gaseous compounds are emitted at variable rates depending on the temperature of the fire and are far less toxic than many ‘natural’ building materials, including wood.

Because of these characteristics, foams used for construction require a covering as a fire barrier. One half-inch thick (1.27 cm) gypsum wallboard is one of the most common fire barriers. Some building codes, however, do not require an additional fire barrier for certain metal-faced, laminated foam products. Check with your local building code/fire officials and insurers for specific information on what is permitted in your area.

Customer Service

870-367-6245
customerservice@drewfoam.com

Our Locations

Drew Foam Co, Inc.

1093 Hwy 278 East
Monticello, AR 71655
(800) 643-1206

Drew Foam of Tennessee

3050 Barry Dr
Portland, TN 37148
(800) 643-1206

Drew Foam of South Carolina

107 Service Road
Anderson, SC 29625
(800) 643-1206

For over 50 years,

Drew Foam has prided ourselves on customer service, providing quality products while exceeding customers expectations and meeting their needs. Whether you are looking for our EPS foam packaging products, insulation, construction materials, or OEM applications, Drew Foam can help.

Copyright ©2017 Drew Foam. All Rights Reserved.